TV No Sound Repairs
TV with picture but no sound is usually an internal-amplifier, speaker, or audio-output fault. Sometimes it is a settings issue — check audio output mode and mute state first. Where the fault is hardware, we repair on site or in workshop.
What Usually Causes This Problem
Most cases trace back to one of the following root causes. Our technicians diagnose with a signal meter and the right diagnostic tools on every callout.
Audio mode set to external speaker
TV is set to output audio via HDMI ARC or optical — but no soundbar is connected. Quick to reset.
Mute or zero volume
Always worth checking — remote handover can leave mute active.
Failed internal speaker
Internal TV speakers occasionally fail. We replace where economical or recommend a soundbar.
Audio amplifier IC failure
The internal amplifier chip can fail. We diagnose with workshop tools.
HDMI audio handshake fault
Sound works on some inputs but not others — usually HDMI ARC negotiation.
Soundbar configuration
If you have a connected soundbar, the issue may be in the soundbar settings or input mode.
Most no-sound faults are settings, not speakers
Before anyone opens a television, these account for the majority of no-sound complaints:
- Muted, or volume on the wrong device. With a decoder, a soundbar and a TV in the chain, there are three volume controls and only one of them is usually the right one.
- Audio output setting. If the TV is set to output to an external system that is switched off or disconnected, the internal speakers stay silent. TV settings › Sound › Output.
- ARC / eARC confusion. HDMI-ARC carries audio back from the TV to a soundbar or receiver, and it must be on the correct HDMI port — usually only one port supports it, and it is labelled.
- Decoder audio format. A decoder outputting Dolby Digital to equipment that cannot decode it produces silence rather than an error. Switching the decoder's audio output to stereo or PCM is the test.
- The HDMI cable. A partly failed cable can carry video and drop audio.
Narrowing it down
- No sound on any input, including the TV's own apps. Points to the television — settings or the audio board.
- No sound from the decoder only. The decoder's audio settings, the HDMI cable, or that input.
- Sound through headphones but not speakers. A speaker or amplifier fault in the TV.
- Distorted or crackling sound. A blown speaker, which is usually replaceable.
- Sound cuts out intermittently. Most often the HDMI cable or connection.
When it is hardware
Blown speakers and failed audio amplifier stages are both repairable on most sets, and both are considerably cheaper than replacing the television. If the sound problem arrived with a picture problem at the same moment, that usually points to the main board rather than the audio section — see TV no picture and our LED TV repair service.
Common questions
Most often a settings issue rather than a fault: the audio output set to an external device, a mute on a different remote in the chain, an ARC misconfiguration, or the decoder outputting an audio format the equipment cannot decode. Switching the decoder's audio output to stereo or PCM is a quick test.
Check the decoder's audio output setting first, then the HDMI cable, then the TV input. A decoder set to Dolby Digital connected to equipment that cannot decode it will produce silence rather than an error message.
Yes, on most televisions. Speaker replacement and audio amplifier repairs are usually far cheaper than replacing the set.
ARC, or Audio Return Channel, sends audio from the television back to a soundbar or receiver over the HDMI cable. It only works on the specific HDMI port that supports it, which is labelled on the TV. Using the wrong port is a common cause of no sound.
Related pages
Related DSTV Solutions
See our FAQ page for 50+ answers, or contact us for a same-day quote.